Previous
Previous Product Image

Honeycomb Bed Pins

200
Next

ORTUR Diode Laser Master 2 Pro S2 LU2-10A

30,000
Next Product Image

ORTUR Laser Cutting and Engraving Machine Pro S2 LU2-4 LF 5.5W

22,000

  •  LU2-4-LF is good at engraving and better at cutting, and could support a higher speed.
  • It is not that the smaller the light spot, the better the effect when engraving photos. You may need to increase the laser spot to get a better picture effect.
  • It has a longer Focal Length, so it has a longer Depth of Field, but a bigger Focal Spot.

Available on back-order

Description

  • Ortur Laser 1.8 firmware is optimized the motion algorithm and increases the maximum motion speed from 4000mm/min to 10000mm/mm, the focal point is only 0.17*0.25mm. The optical power reaches 4500-5500mW. So it can cut through 4mm plywood and 10mm pine board at a time. At the same time, the laser cutter comes with an air assist nozzle, use with our air pump could support a higher speed and cut better.
  • Laser Master newly upgraded 5 Safety protection. 1. When the engraving machine is displaced or tilted, it will automatically stop the laser; 2. When the engraving machine or computer crashes, the laser will stop working immediately. 3. The engraving machine is turned on, but there is no movement for a long time, the laser will be turned off automatically. 4. Flame Detector + Buzzer Alarm 5. Emergency stop switch for an emergency.
  • 1. The laser engraving machine is equipped with the latest OLM-PRO-V10 motherboard, It could preprocess 32 instructions, support baud rate as high as 921600 the engraving accuracy is higher, and the speed is faster. 2. The circuit system with 24V voltage is upgraded, the current is lower, and the system is safer. 3. Update Ortur Laser 1.8 firmware, which is the most advanced laser engraving machine firmware at present. 4. Support Ortur offline control screen.
  • Pre-assembled parts, just need 10 – 20 minutes to install the laser machine. Aluminum profile frame + structured cabling, solid structure, smooth operation. Synchronizing shaft mechanical structure, avoid out-sync on two Y rails, during full speed engraving.

Reviews

There are no reviews yet.

Be the first to review “ORTUR Laser Cutting and Engraving Machine Pro S2 LU2-4 LF 5.5W”

Your email address will not be published. Required fields are marked *

Shopping cart

0
image/svg+xml

No products in the cart.

Continue Shopping